Herunterladen Inhalt Inhalt Diese Seite drucken

Inserting/Replacing The Pre-Filter; Inserting/Replacing The Combination Filter; Cleaning The Inside Of Hoses And Arms - ersa EASY ARM 1 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für EASY ARM 1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Maintenance
8.1

Inserting/Replacing the Pre-Filter

8.2

Inserting/Replacing the Combination Filter

8.3

Cleaning the inside of hoses and arms

26
The pre-filter must be inspected every three months and replaced if
necessary.
Make sure the device is switched off.
Open the cover of the extraction device by pressing the lugs on the hous-
ing sides inwards.
Remove the used pre-filter.
Insert the new pre-filter with the white side facing up.
Re-attach the cover of the extraction device. Make sure that the lugs on
the housing sides are both engaged again.
The device is ready for use again.
Make sure the device is switched off.
Open the cover of the extraction device by pressing the lugs on the hous-
ing sides inwards.
Remove the used pre-filter and the combination filter.
Note down the replacement/insertion date on the label of the new com-
bination filter.
Insert the new combination filter centrally into the housing.
Insert the new pre-filter with the white side facing up.
Re-attach the cover of the extraction device. Make sure that the lugs on
the housing sides are both engaged again.
Reset the filter operating hours (see Chapter 6 and Figure
The device is ready for use again.
Clean dry with a dishwashing brush.
Then blow out with compressed air.
3BA00216 • 2023-02-17 • Rev. 3
).
Ersa EASY ARM 1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis