Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance; Optional Accessories; Battery Disposal - Concept SC4000 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SC4000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 39
EN
BATTERY REPLACEMENT
1. Removing the battery from the electric scooter
1. Press the lock button on the
top of the battery. Push away
from the scooter column.

CLEANING AND MAINTENANCE

• Always make sure that the battery and charger of the electric scooter are disconnected from the power supply. The
electric scooter must be switched off.
• Dampen a soft cloth with clean water and use it to clean the electric scooter. Never use an excessive amount of
lubricating oil when performing bearing maintenance.
• It is forbidden to clean the electric scooter using water spray or immerse it into water and other liquids. This would
permanently damage the electrical components.
72
2. Pull the battery upwards.
3. Remove the battery from
the column.
2. Installing the battery into the electric scooter
1. Slide the battery into the
2. Insert the battery into the
column.
grooves on the column and
slide it down the column until
the lock button clicks.
SC4000, SC4010
STORAGE
• Before storage, fully charge the battery to prevent damage to the battery caused by over-discharge during long-
term storage.
• Recharge the battery at least once every three months.
• Do not charge the battery if the storage temperature is below 0 °C. Move the battery to a room with a room
temperature and then charge it.
• Store your electric scooter in a suitable dry interior. The electric scooter can be covered to prevent dust on settling
on it.
TROUBLESHOOTING
Problem
The electric scooter does not start
Charge the battery.
Make sure that the charger is correctly connected to the wall outlet, if not,
connect the charger to the mains.
The electric scooter does not charge
Make sure that the charger of the electric scooter works (the indicator is on).
Make sure that the plug of the charger and the charging port of the electric
scooter are correctly connected.
The battery life is over – replace the battery with a new one. Contact an
Reduced performance of the battery
authorized service centre.
The motor is not working
Contact an authorized service centre.
The brakes make a grinding or whistling noise – check their adjustment.
If the clamping element of the brakes is loosened, tighten the bolts and
Brakes
adjust the brakes.
If the brakes and brake pads are dirty and offer poor braking power, clean the
brakes with clean water.
If the instructions in the table above do not help you to solve the problem, contact your dealer or an authorized service
centre. Any modifications and repairs you make to the electric scooter may damage the appliance and subsequent
warranty claims will not be accepted!

OPTIONAL ACCESSORIES

Bag
product code 42393855
Mobile phone holder
product code 42393856
Spare battery
product code 42393861

BATTERY DISPOSAL

The appliance contains a Li-ion battery. This type of battery contains substances that can damage the environment in
their disintegration. Before disposing of the appliance or replacing the battery, the original battery must be removed
and returned to an appropriate collection point.
SC4000, SC4010
EN
Remedy
73

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sc4010

Inhaltsverzeichnis