Battery Replacement; Cleaning And Maintenance - Concept SC4000 Bedienungsanleitung

EN
Output voltage
Output current
Storage temperature
SAFE USING OF THE BATTERY
Stop using the battery in the following cases:
• Use the battery of the electric scooter only in accordance with local laws. Contact a qualified person to remove and
replace the battery.
• Do not touch any substances leaking from the battery. If the battery starts to produce an unpleasant odour or gets
too hot, stop using it.
• Do not use the electric scooter during charging. Always disconnect the battery from the charger before ride and
installation.
• Do not let children and animals touch the battery!
• To ensure proper operation of the battery, pay attention to the storage and charge temperature. Always observe
the temperature range given in the specifications.
• Always follow local laws when transporting lithium batteries. Lithium batteries are considered dangerous.
• The battery contains dangerous substances, never open the battery. Do not insert anything into the battery.
• It is forbidden to charge a lithium battery that has been over-discharged. These batteries represent a safety hazard,
hand them over to the appropriate collection point.
• If the internal temperature of the battery exceeds 45 °C, the protection system will be automatically activated.
• Do not charge the battery if the outdoor or indoor temperature exceeds 40 °C.
• Never leave the electric scooter on a direct sunlight. This could damage the battery.
• Use only original chargers to charge the electric scooter.
CHARGING PROCEDURE
First charging method:
• Open the charging port cover and make sure that the charging port is clean
and dry.
• Connect the charging device to the battery and the other end to the power
supply (100-240 V).
• If the indicator on the charger lights up red, the battery is charging properly.
If the indicator does not light up, check the connection to the mains.
• If the indicator on the charger lights up green, the battery is charged to 99
%. Stop charging the battery. Prolonged charging of the battery affects its
lifespan.
Second charging method:
• Remove the battery from the electric scooter. Remove the silicone cover
from the charging port, then connect the DC connector of the charger to
the charging port of the battery.
• Plug the power cord into the charger and the second port into a wall outlet
(100-240 V). Check whether the charger indicator is on.
Battery interface
Charging port
70
42 V
2 A
-8 °C–35 °C
SC4000
• Once the indicator lights up green, charging is complete.
• After charging, cover the charging port with the silicone cover which protects the port from dust and prevents
contact with foreign metal objects that could cause a short circuit.

BATTERY REPLACEMENT

1. Removing the battery from the electric scooter
1. Press the lock button on the
top of the battery. Push away
from the scooter column.

CLEANING AND MAINTENANCE

• Always make sure that the battery and charger of the electric scooter are disconnected from the power supply. The
electric scooter must be switched off.
• Dampen a soft cloth with clean water and use it to clean the electric scooter. Never use an excessive amount of
lubricating oil when performing bearing maintenance.
• It is forbidden to clean the electric scooter using water spray or immerse it into water and other liquids. This would
permanently damage the electrical components.
SC4000
EN
2. Pull the battery upwards. 3. Remove the battery from
the column.
2. Installing the battery into the electric scooter
1. Slide the battery into the 2. Insert the battery into the
column. grooves on the column and
slide it down the column until
the lock button clicks.
71