Operation Of The Device; Cleaning And Maintenance - Stalgast 484416 Bedienungsanleitung

3. CONSTRUCTION OF THE DEVICE
1
3
5
6
8

4. OPERATION OF THE DEVICE

1. Make sure the ON/OFF switch is in the OFF (off) position.
2. Insert the power plug into the power outlet.
3. Place the pitcher in the drive socket. Make sure it is correctly and stably attached.
4. Put on the lid of the jug.
5. Ustawić przełącznik ON/OFF na pozycję ON (włączony).
Note: Be sure to hold the jug by the handle while the machine is running.
6. Cutting element speed adjustment:
• LOW - lowest speed
• HIGH - highest speed
• PULSE (increased speed, requires holding down the button while the blender is running).
Start operation: Press the button of the selected mode, to finish press the selected mode again.
4.1. NOTES
1. Before using, place the blender on a clean, dry and flat surface.
2. Before crushing ice, place any liquid ingredient in the container.
3. Do not use the blender when the container is empty and do not remove or rearrange the container when the unit is
on.
4. Do not turn on the device without the container in place
5. Carefully remove any traces of water on the pad before use. Otherwise, water may be drawn into the unit and cause
damage to the motor.
6. Make sure the blender jug is securely attached to the main unit before use.

5. CLEANING AND MAINTENANCE

To clean the container:
• Pour a small amount of warm water with dishwashing liquid into the container.
• Put the lid on and turn the blender on for about 10 seconds.
2
4
1. lid cap
7
2. jug lid
3. jug
4. attachment mat for jug
5. infinitely variable speed regulator
6. on/off switch
7. pulse switch
9
8. base
9. rubber feet
- 9 -