NEXPEAK NC350 Bedienungsanleitung Seite 9

3. Can't fully charged after a long time.
Reason: battery vulcanization or lack of water also low voltage can lead to
this situation, the battery will become hot while charging.
Solution: Stop charging. Check whether the battery liquid was leaked if it's
a wet battery.
4. Can't automatically sense it's on a 24V battery, hooked up to 24V
batteries, but stays in 12V mode, says full.
Reason: 24v battery contains two of 12V batteries, its real voltage could
be 8-10v for long time power loss, so the battery charger will charge it on
12V battery mode and in this way can't charge the 24V batteries
successfully.
Solution: Charge two of the 12V battery separately and it will turn to 24V
mode after charging to a certain voltage then charge 24V batteries.
5. Tried charging a battery overnight for over 8 hours and no charge at all,
kept blinking the battery percentage icon all night long.
Reason: battery charger can not charge totally dead batteries(0V or bad
cells contained).
Solution: try repair function or replace this battery directly.
2 Year Hassle-Free Warranty
NEXPEAK warrants that this product will be free from defects in material
and workmanship for a period of two (2) years from the date of purchase
(the "Warranty Period" ). For defects reported during the Warranty Period,
NEXPEAK will, at its discretion, and subject to NEXPEAK' s technical
support analysis, either repair or replace defective products. Replacement
parts and products will be new or serviceably used, comparable in function
and performance to the original part and warranted for the remainder of the
original Warranty Period.
NEXPEAK'S LIABILITY HEREUNDER IS EXPRESSLY LIMITED TO
REPLACEMENT OR REPAIR. TO THE MAXIMUM EXTENT PERMITTED
BY LAW, NEXPEAK SHALL NOT BE LIABLE TO ANY PURCHASER OF
THE PRODUCT OR ANY THIRD PARTY FOR ANY SPECIAL, INDIRECT,
CONSEQUENTIAL OR EXEMPLARY DAMAGES, INCLUDING, BUT NOT
LIMITED.
Contact us: support@nexpeaktech.com
Web: www.nexpeaktech.com
8 - EN