Safety Instructions; Component List - Kress KU059 Bedienungsanleitung

SAFETY INSTRUCTIONS

WARNING! When using this product basic safety
precautions should always be followed. Failure
to follow all instructions listed below may result in
personal injury.
Read all these instructions before attempting to
operate this product and save these instructions.
1. Keep work area clear and well lit.Cluttered
areas and benches invite injuries.
2. Make sure all moving parts are free from
interference.
3. Ensure workstation is set up on firm, level
ground in a stable manner.
4. Keep other persons away.Do not let persons,
especially children, not involved in the work touch
the tool and keep them away from the work area.
5. Be aware of over-balancing. When a
large piece is cut from one end of a job, the
remaining piece may be heavy enough to tip the
workstation. Always ensure the workpiece is well
supported.
6. Check to make sure that all fixing screws
and knobs are tight and all legs are
locked into place before operating the
workstation.
7. The tool must be used only for its
prescribed purpose. Any use other than
those mentioned in these instructions will be
considered a case of misuse. The manufacturer
shall not be liable for any damage or injury
resulting from such cases of misuse.
8. Never stand on this product.
9. Dress properly. Do not wear loose clothing
or jewelry, they can be caught in moving parts.
Non-skid footwear is recommended when
working outdoors. Wear protective hair covering
to contain long hair.
10. Use personal protective equipment. Use
safety glasses. Use face or dust mask if working
operations create dust.
11. Save all warnings and instructions for
future reference. Refer to them frequently
and use them to instruct others who may use
workstation. If you loan someone workstation,
loan them these instructions also to prevent
misuse of the product and possible injury.
12. Do not use tools in damp or wet locations.
Moist work piece and environment can not clamp
firmly.
13. Ensure the work piece was clamped firmly
and the lock release switch is on proper
state before use.
14. Check damaged parts. Before further use of
tool, it should be carefully checked to determine
that it will operate properly and perform its
intended function.
15. When not in use, tools should be stored
in a dry locked-up place, out of the reach
of children and do not allow persons
unfamiliar with it.
16. Have your workstation serviced by a
qualified repair person.
17. Warning! The use of any accessory or
attachment other than one recommended in this
instruction manual may present a risk of personal
injury.
SYMBOLS
Read the operator's manual.
Warning
Wear eye protection
Wear ear protection
Pinch points
Wear gloves

COMPONENT LIST

1. MOVING JAW
2. MOVING JAW FACING (2 PIECES)
3. FIXED JAW FACING
4. MAIN BODY
5. REAR LEG LOCKING KNOB
6. REAR LEG
7. RUBBER FOOT PAD
8. FOOT PLATE
9. FOOT PEDAL COMPONENT
10. FRONT LEG
11. FOOT PEDAL LOCKING LATCH
12. ROLLER
13. LOCK/RELEASE SWITCH
14. FIXED JAW
15. FRONT LEG LOCKING LATCH
Not all the accessories illustrated or described
are included in standard delivery.
7
EN