Werbung
TROUBLESHOOTING
Please follow the below instruction in case of any defect
Problem
The power
indicator light
does not
flash
No filament
come out from
nozzle
Not heated
FILAMENT CUT
Please make sure that you have
correctly cutted the filament end
before using!
Reason
The power adapter or plug line defective
Motherboard defective
Socket lead off
Nozzle blocked
Temperature is not high enough
No working temperature
Gear slips
Fail to load filament
Motherboard defective
Heating part defective
Heating part defective
Correct
All brands and logos are registered trademarks of their respective owners
FREE FORM 3D PRINTING PEN FOR ABS/PLA FILAMENT
Repair or replace the power adapter
Repair or replace the motherboard
Sold the socket
Replace the nozzle set
Replace the nozzle set or adjust the
temperature
Replace the nozzle set or check the
motherboard
Back wire, cleaning gear, cut off the
damaged supplies after the reloading
Unload filament and cut the end of
filament well
Repair or replace the motherboard
Replace the nozzle set
Replace the nozzle set
Wrong
Wrong
GEMBIRD EUROPE B.V.
3DP-PEN-01
Solution
http://www.gembird.eu
5
Werbung
