Safety Instructions - Hard Head 024169 Bedienungsanleitung

SAFETY INSTRUCTIONS

Read these instructions before assembly and
use, and save them for future reference.
IMPORTANT:
Note the overall weight of the canopy roof.
It is not only the roof that must support this
weight. The wall attachments must also
support the weight.
• Mount the product in a supporting
structural part of the building. Otherwise
there is a risk of serious personal injury or
material damage.
• Recommended precautions on
installation:
– at least 2 persons
– wear safety gloves
– wear safety glasses.
• Do not attempt to assemble the product
in the following conditions:
– rain
– strong wind
– tiredness or under the influence of
drugs, alcohol or medication.
• In the event of snowfall, remove snow
from the product.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
TECHNICAL DATA 024169
Width
Depth
Max load
Resistance to wind load
Lowest temperature
TECHNICAL DATA 024170
Width
Depth
Max load
Resistance to wind load
Lowest temperature
DESCRIPTION
UV protected canopy roof with brackets
made of aluminium and tinted panel of
polycarbonate. Withstands cold winters down
to -30°C. Assembly screws included.
ASSEMBLY
Assemble as shown in the figures.
FIG. 1
1. Wipe the edgings with detergent before
assembly.
FIG. 2
2. Fit the edgings on the panel.
FIG. 3
3. Fit the brackets on the polycarbonate roof.
FIG. 4
4. Mark out on the wall where the attachment
holes for the brackets are to be drilled.
5. Drill the holes.
6. Screw the canopy roof in place.
7. Seal with uncoloured silicone.
FIG. 5
MAINTENANCE
CLEANING
150 cm
Clean the product with a mild detergent and
100 cm
rinse with cold water. Do not use acetone or
60 kg other solvents, strong or abrasive detergents,
or hard or abrasive utensils that can damage
Class 4
the surface.
-30°C
EN
200 cm
100 cm
100 kg
Class 4
-30°C
11