Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Read and understand all instructions prior to using your
Oster
Rapid Bathing System
TM
Before you begin:
• Your pet will soon be enjoying the relaxing massage the Oster
System provides while receiving a thorough, deep down cleaning. With experience,
most pet owners find that they can completely bathe their pets in under 3 minutes!
The amount of time it takes will vary based on the size of the animal, coat thick-
ness and length, and dirtiness level.
• While the device is designed to work either inside or out, your pet will enjoy the
experience even more when warm water can be used for bathing.
• You will need to use a water source that has a flow rate that exceeds 3 gallons
(11.35 liters) per minute. The vast majority of homes will meet this requirement
both in the shower and at an outside water faucet. Building codes limit the amount
of water pressure to sinks; the Oster
for use at the sink.
Oster
Bathing System Installation:
TM
Outdoor Installation:
If your outdoor water faucet has a quick release system installed:
1. Connect the quick release unit and/or adaptor if needed to one end of your garden
hose or the hose provided in your Oster™ Rapid Bathing Kit.
2. Connect the other end of the hose provided or your garden hose to the Oster™ Rapid
Bathing Unit. The Oster™ unit is designed to fit most garden hoses, if you have
difficulty connecting to your garden hose an adapter may be needed.
3. You are now ready to connect the quick release side of the hose to your
faucet adaptor.
4. Proceed to the Shampoo Selection instructions section.
If you would like to connect directly to the outdoor water faucet:
1. Attach the Oster™ unit directly to the end of a garden hose 50 feet (15 meters) or
shorter. The Oster™ unit is designed to fit most garden hoses, if you have difficulty
connecting to your garden hose an adapter may be needed.
2. Proceed to the Shampoo Selection instructions section.
Indoor Installation:
1. To use the Oster™ Rapid Bathing system inside, carefully remove your current shower
head or hand-held shower head.
2. The included diverter is designed to fit virtually all standard shower pipes. In the event
of a non-standard shower pipe, an adapter can be purchased at a local home improve-
ment store. When attaching the adapter, consider using Teflon tape to ensure a water
tight seal. If you do not wish to leave the diverter in place when not using the Oster ™
system, attach the included hose directly to the shower pipe using the adapter.
3. If using the diverter, reattach the shower head.
4. Attach the Oster™ bathing unit to the other end of the hose.
Rapid Bathing System unit is not designed
TM
Rapid Bathing
TM
Werbung
Inhaltsverzeichnis
