Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
typical housekeeping functions that may also be used by non-expert
users for typical housekeeping functions, such as: shops, offices
other similar working environments, farm houses, by clients in
hotels, motels and other residential type environments and/or in
bed and breakfast type environments.
The product is not intended for professional use.
This product is only suitable for well insulated spaces or occasional
use.
Main parts (image A)
Control panel
1
2
Radiator
Castor mounting plate (2x)
3
4
U-shaped castor mounting
plate*
* HTOI30WT7 only.
Control panel (image B)
Power dial
1
2
Thermostat dial
Safety instructions
-
WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep the
packaging and this document for future reference.
• Only use the product as described in this document.
• Misuse of this product can result in serious injury.
• Do not use the product if a part is damaged or defective. Replace
a damaged or defective product immediately.
• Do not use the product if the surface is cracked.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified technician for
maintenance to reduce the risk of electric shock.
• Do not plug the product in a power outlet of a power group with
other products that consume a lot of power.
• Do not plug the product in a power outlet with a current of less
than 10 A.
• This product may not be used by persons (including children)
whose physical, sensory or mental capabilities or lack of
experience and knowledge prevents them from using the
product safely without supervision or instruction.
• Children should be supervised to ensure that they do not play
with the product.
• Do not expose the product to water or moisture.
• Do not use the product where splashing of water might occur,
e.g. bathroom, swimming pool or close to a washbowl.
• Do not use the product in a room with an area smaller than 5 m
• Keep the product at a minimum distance of 1 m away from
flammable or combustible materials.
• Before use, always check that the mains voltage is the same as
the voltage on the rating plate of the product.
• Do not use an extension cord or power strip, which could
overheat and result in a fire.
• Only plug the cable into a wall outlet. Do not use extension
cords.
• Unplug the product from the power source if problems occur.
• Unplug the product and set dials to zero when not in use and
before cleaning.
• Do not unplug the product by pulling on the cable. Always grasp
the plug and pull.
• Do not use external timers or remote control systems to switch
the product on or off.
• Do not plug the product in a power outlet of a power group with
other products that consume a lot of power.
• Do not locate the product immediately below a power outlet.
• Do not cover the power cable by e.g. carpets, rugs or furniture.
HTOI30WTxx_MAN_COMP_(220362 14022)_v01_01.indd 5
HTOI30WTxx_MAN_COMP_(220362 14022)_v01_01.indd 5
Cap nut (4x)
5
6
Castor wheel (4x)
Power cable
7
8
U-shaped bolt (2x)
Wing nut (2x)
9
Power indicator LED
3
2
.
• Do not let the power cable hang over the edge of a table or
counter, or touch hot surfaces.
• Do not leave the product unattended when the product is
connected to the power outlet.
• Disconnect the product from the power source before service
and when replacing parts.
• If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• The surfaces of the product get hot during use. Only touch the
handles of the product to avoid burns.
• Do not use the product outdoors, the product is designed for
indoor use.
• To avoid overheating, do not cover the product.
• Only use the product in a well-ventilated area.
• Do not block the air in- and outlets of the product.
• Do not allow this product to come in contact with curtains, wall
coverings, clothing, dishtowels or other flammable materials
during use.
• Do not use the product in rooms where flammable liquids or
gases are used or stored.
• Do not try to open or repair the product, controller or cable. It
must be serviced by a qualified technician.
• Dispose of the oil separate from the product. Check the local
rules and regulations for the correct disposal instructions.
• Do not use the product when it is leaking oil.
• Only use the product in the upright position.
• Do not move the product during operation.
Explanation of the safety symbols on the
product
Icon
Description
To avoid overheating, do not cover the product.
Assembling the product (image C)
1. Remove all packaging.
2. Carefully place A
2
upside down on a soft surface.
3. Place the U-shaped bolt A
8
behind the front cover.
4. Place the hook of A
8
through the slot on the castor mounting
plate A
3
.
5. Place the thread A
8
through the other slot on A
6. Screw the wing nut A
on A
9
-
Do not overtighten the bolts. This will damage the product.
7. Place the castor wheel A
6
8. Screw the cap nut A
5
on A
Repeat steps 3 - 8 for between the last two fins on the other side of
the product.
The HTOI30WT7 has a U-shaped castor mounting plate A
4
Place A
4
between the first and second fin behind the front cover.
Point the ends of A
to A
.
4
1
Installing the product
1. Place the product on a stable and flat surface.
2. Turn the power dial B
1
and the thermostat dial B
and MIN position.
3. Connect the power plug A
7
Using the product
1. Rotate the thermostat dial B
2. Rotate the power dial B
1
5
between the first and second fin
3
.
8
.
in the hole of A
3
.
6
.
.
4
2
to the 0
into a power outlet.
2
to the MAX position.
to the desired mode:
8-6-2022 14:59:15
8-6-2022 14:59:15
Werbung
Inhaltsverzeichnis
