Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL DATA
Type KUD12 KUD12.91(D12-representative of
high frequency oscillation tool )
Rated Voltage
Oscillations per minute
Oscillations angle
Speed selection
Machine weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K
&K
pA
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value a
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
KUD12
KUD12.91
20V
Max**
8000-18000opm
3.2°
6
1.86kg
1.2kg
L
= 81.1dB(A)
pA
L
= 92.1dB(A)
wA
3dB(A)
= 3.635m/s²
h
Uncertainty K = 1.5 m/s²
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Charger (KAC21)
Battery pack(KAB21)
Smaller flange (for other
brands' sanding pad,
such as Bosch/Dremel/
Chicago Electric etc.)
Sanding paper (40#, 80#,
120#)
45mm precision wood
plunge cut blade
28mm end cut blade
Sanding pad
HSS semicircle saw
blade
10mm end cut blade
Rigid scraping blade
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and offer
advice.
KUD12
KUD12.91
1
/
2
/
1
1
36
18
1
1
1
1
1
1
1
1
1
/
1
1
9
EN
Werbung
Inhaltsverzeichnis
