Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Exploded drawing
Technical data
Model
Voltage
JVP-101/B/AB
220V
JVP-102/B/AB
220V
JVP-201/B/AB
220V
JVP-202/B/AB
220V
Safety Notice
Attention: please make sure that all pump parts are intact before switching on the wave maker. Do not
connect it to voltage supply sources whose voltage do not match the one indicated on the device.
There must be no sand in the pump, otherwise component parts are destroyed. Pump damage caused
by sand is not covered by warranty.
Due to the strong magnetism it must be stored out of reach of children.
Place the magnets on the two sides of the aquarium wall. Avoid putting your hands or fingers between
them as this can cause injury.
If the distance between the magnets and other metal parts or other magnets is only 5 cm, the
magnetism between them is very strong. To avoid injuries please keep a sufficient distance of the
pump magnets from narrow edges, sharp items and other magnets.
These magnets can cause permanent damage to electrical equipment or other devices for example:
pace makers, credit cards, keys. For this reason keep a 30 cm distance.
To avoid damaging the aquarium, please proceed as illustrated in picture 4 when positioning the
magnets: Do NOT move the magnets from both glass sides perpendicularly towards each other
(Never put the external and internal magnet directly together) but place them shifted from one another
and slide them across the glass till they join up.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Frequency
Power
50Hz
6W
50Hz
12W
50Hz
12W
50Hz
24W
Water flow
Weight
3000l/h
0,5kg
5000l/h
0,5kg
6000l/h
0,5kg
12000l/h
0,8kg
Seite 7
Werbung
