WilTec Wave Maker 50233 Bedienungsanleitung Seite 6

Setting:
1. Clean the aquarium before using the pump. Dirt on the aquarium glass panes prevents a correct
installation. If the pump slips off it can damage itself or the glass walls of the aquarium (dirt can impair
the grip of the magnet/ suction attachments). To avoid disruptions caused by noise and vibrations the
pump should be fixed under the water surface.
2. Remove the cable.
3. Install the magnet or the suction cups by pushing the rotatable axis into the back part of the wave
maker. Picture1
4. Immerse the pump fully in the water and connect the two parts. Picture 2. The glass panels of the
aquarium must be free of dirt! If your pump has suction cups simply press these against your aquarium
glass to hold the wave maker in place.
5. After the wave maker has been fully submerged and fixed into place connect it to the power mains.
6. In case of the vibration pump with magnetic fixation you must position the pump in the aquarium
tank against the glass. Place the external magnet against the glass but not directly against or near the
wave maker unit inside the tank. Then slide the external magnet across the glass wall till it meets the
internal magnet. The magnets are very strong and should be handled with care and caution. Do not
release or drop the external magnet at a distance against your glass or internal magnet because this
could lead to damage of your fish tank.
Maintenance
1. Clean and maintain your circulation pump regularly so that it has a long lifespan.
2. Use one hand to grip the pump unit (motor) and with the other hand to remove the magnetism/
suction cups of the outside the tank/aquarium and release the font part of the pump.
3. Open the pump assembly like showed in picture 3.
4. Make sure when you clean the impeller to gently remove dirt and handle it with care, do not use
washing liquids or impregnating agents.
5. Reassemble the pump in reversed order. Ensure that both main parts fit together perfectly and the
shaft is properly positioned.
Notice:
Not all pump models are equipped with magnets but they are available on request.
© by WilTec Wildanger Technik GmbH Seite 6
http://www.wiltec.info