Description Of Parts; Charging The Unit; How To Connect The Cutting Attachments - Trevidea Girmi Rc30 Bedienungsanleitung

- The charging adapter contains a power transformer, it is
recommended not to change the type of plug as this
could cause a hazardous situation.
- Operating temperature 15-35 ° C. If the unit is subject to
a major change in temperature, pressure and humidity,
wait about 30 minutes before using it.
- Use only original AC/DC adapter to recharge the device.
- This unit was created for cutting hair, shorten beard,
sideburns and mustache and as a nose/ears trimmer; any
other use is considered dangerous.
- Do not tick and / or cut your eyebrows and eyelashes
with this unit.
WARNING: never use the unit for any reason
inside the bath or in the shower. Avoid any
splashes of water from getting inside the device. If this
happens, the hair clipper must be checked by qualified
personnel before operating it again.
DESCRIPTION OF PARTS RC30
A) Hair clipper comb (4 pieces)
E) Nose/ear trimmer
K) AC/DC adapter
N) Charging light
Q) Cleaning brush

CHARGING THE UNIT

Fully charge the unit before using or after a long period of inactivity. The full charge takes about 8 hours and
provides an operating time range of 45 minutes.
CAUTION: When charging, make sure the unit is off.
Direct charging: connect the plug (K) to the power socket on device (P) and plug the adapter into a socket
compatible. The red charging light turns on to indicate that the unit is charging.
- Disconnect the charging adapter from the outlet when the device is fully charged (about 8 hours).
- Do not overcharge the unit by leaving it connected to the power outlet for more than 24 hours.
- To improve the unit performance, we recommend charging the battery twice a year, by letting the motor run
until it stops completely. Then fully recharge it for 8 hours.
HOW TO CONNECT CUTTING ATTACHMENTS
All cutting attachments such as hair-clipper (B), shaver (C), nose trimmer (E), beard trimmer (F), body
trimmer (H) and the precision trimmer (O) can be connected and disconnected to the unit in the same way.
Follow the below steps:
1. To connect the attachment to the unit, press the accessory against the unit until it locks.
2. To disconnect the cutting accessory, pull the attachment from the blade side, and detouch it.
B) Hair clipper attachment
F) Beard trimmer
J) Appliance plug
O) Precision trimmer
R) Charging stand
C) Shaver
G) Beard trimmer comb
M) ON/OFF switch
P) Power socket
S) Lubricating oil
12