Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 2 - Pre-assemble the Single Clamps
•
For the single-sided clamp, interlock the
teeth and feed the M10x110mm Bolt
through the hole as shown.
•
Do not tighten the bolt fully, only lightly
to keep the sub-assembly together.
Item ID
Clamp (matching halves)
2
B
M10x100mm Bolt
C
Step 2.1 - Pre-assemble the Double Clamps
•
For the double-sided clamp, push the
M12 bolts through both clamps and
secure with a nut.
•
Do not tighten the bolts fully, only
lightly to keep the sub-assembly
together.
Item ID
Clamp (matching halves)
2
J
M12x40mm Bolt
I
•
Slide the pre-assembled clamps over
the post.
•
If angled clamps are used in your
cubicle (Calm model only), lower the
angled clamp first as shown in Appendix
A/B.
•
When the clamp is in place, the bolt can
be slightly tightened to hold it in place.
DO NOT OVERTIGHTEN, as further
adjustment may be required.
Parts List
Part Name
M10 Locknut
Parts List
Part Name
M12 Locknut
Step 3 - Slide on the Clamps
Qty.
1
1
1
Qty.
1
4
4
Date:
Rev.
28/06/2022
www.easyfix.com
Page 7/16
A10
Werbung
Inhaltsverzeichnis
