General Power Tool Safety Warnings - BELLOTA M18 Bedienungsanleitung

WARNING
Read all safety warnings and instructions. Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Work area safety
1.
a) Keep work area clean and well lit. Cluttered or dark areas are prone to accidents.
b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool. Distractions can cause you to
lose control.
Electrical safety
2.
a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk
of electric shock.
b) Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.
c) DO not expose power tools to rain or wet conditions. Water entering a power tool will increase the
risk of electric shock.
d) Do not mistreat the power cord. Never use the cord for carrying, pulling, or unplugging the power
tool. Keep the cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords
increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. The use of
a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use a Residual Current Device (RCD)
protected supply. Using an RCD reduces the risk of electric shock.
NOTE: The term "Residual Current Device (RCD)" may be replaced by the term "Ground-Fault Circuit Interrupter (GFCI)" or
"Earth Leakage Circuit Breaker (ELCB)".
Personal safety
3.
a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not
use a power tool while you are tired or under the influence of drugs, alcohol, or medication. A
moment of inattention while operating power tools may result in serious personal injury.
b) Use personal protective equipment. Always wear eye protection. Protective equipment such as
dust mask, non-skid safety shoes, helmet, or hearing protection used for appropriate conditions will
reduce personal injuries.
c) Prevent unintentional starting. Ensure the switch is off before connecting to power source and/or
battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or
energizing power tools that have the switch on may cause accidents.
d）Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left
attached to a rotating part of the power tool may result in personal injury.
e) Do not overreach. Always keep proper footing and balance. This enables better control of the

GENERAL POWER TOOL SAFETY WARNINGS

EN
18