Specifications - Kicker PXA-Serie Benutzerhandbuch

Specifications

Model:
Dynamic Power
RMS Power Output
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω mono, ≤ 1% THD+N
@ 14.4V, 2Ω mono, ≤ 1% THD+N
@ 14.4V, 1Ω mono, ≤ 1% THD+N
Frequency Response [Hz]
Selectable Electronic Crossover
KickEQ™ Bass Boost
Fader On/Off Switch
Length [in, cm]
Height [in, cm]
Width [in, cm]
Signal-to-Noise Ratio [dB]
Signal-to-Noise Ratio [dB]
Input Sensitivity
Note: All specifications and performance
figures are subject to change. Please visit
www.kicker.com for the most current
information. To get the best performance
from your new KICKER speakers, we
recommend using genuine KICKER
accessories and wiring. Please allow two
weeks of break-in time for the speakers to
reach optimum performance.
Pro Tip: You're a KICKER amplifier and a
few cables away from a full system upgrade
that will dominate any factory system!
KICKER line of amplifiers make it easy to
upgrade to solid bass with your existing
or stock source unit. Also, ask your dealer
about KICKER Speaker upgrades.
English
PXA300.1 PXA600.1
500W 850W
150W x 1 300W x 1
250W x 1 500W x 1
300W x 1 600W x 1
25Hz – 200Hz 25Hz – 200Hz
12dB/Octave 12dB/Octave
Lo-Pass Lo-Pass
60/80/100/120 Hz 60/80/100/120 Hz
Selectable 0/+6db Selectable 0/+6db
Bass Boost @ 40 Hz Bass Boost @ 40 Hz
N/A N/A
9-3/4, 24.8 9-3/4, 24.8
1-7/8, 4.7 1-7/8, 4.7
4-1/2, 11.5
>95dB, a-weighted, re: rated power
>75dB (ref: 1W output)
Low Level: 125mV–5V
High Level: 1V–40V
PXA400.4 PXA1000.5
800W 1400W
100W x 4 100W x 4
100W x 4 100W x 4
200W x 2 200W x 2 (Amp 1 and 2) 300W X 1 (Sub)
500W X 1 (Sub)
600W X 1 (Sub)
10Hz – 20KHz Full Range 10Hz - 20KHz,
Sub 25Hz - 200Hz
24dB/Octave 24dB/Octave
Hi-Pass 80/120 Hz, Hi-Pass 80/120 Hz (Amp1 and Amp2),
Lo-Pass (80 Hz only) Lo-Pass 60/80/100/120 Hz (Sub only)
N/A (Sub Only)
Selectable 0/+6db Bass Boost @ 40 Hz
Yes (2) One for Amp 2, One for Sub Input
9-3/4, 24.8 12-7/8, 32.8
1-3/4, 4.5 1-15/16, 5
4