Beeper RX-32 Bedienungsanleitung Seite 9

CONNECTING THE CAMERA (next)
This switch must be placed on or under the dashboard, easily accessible by the driver. It turns off the
B
screen and the front camera when you do not need it. Especially for cameras operating when the
vehicle comes into contact (see point C).
If the camera is to operate when driving forward, please connect the red wire to the + 12V AFTER
C
CONTACT. The switch must be installed, it will disable it if necessary.
If the camera is a rear view camera (rear view when reversing only), please connect the red wire to the
+ 12V REAR LIGHT. In this case, the installation of the switch is not necessary.
D
The black wire must be connected to ground (-).
E
The RCA connector of the camera must be connected with the extension cable of 8 m.
9