Getting Started; How To Use - SwissHome SH-6645 Bedienungsanleitung

GETTING STARTED

Charging the toothbrush
• Be sure to turn off the toothbrush before charging.
• Place the handle in the charger. If the battery capacity below 20%.
The charging indicator will light up red. (Fig.1)
• The charging indicator will change into green after charging for a
while and will always on after fully charged.
• The red indicator on reminds need to be charging.
NOTES:
• It takes at least 16 hours to charge the battery fully.
• The toothbrush must be charged for 16 hours, if:
a. this is the first time using the toothbrush;
b. the toothbrush has not been used for more than 3 months;
• To keep the battery fully charged, we recommend that you keep the toothbrush in the charger when not
in use.
• During charging, the toothbrush will get warm, but this is normal.
• The operating duration will become shorter as the battery gets older.
If the toothbrush operates only for 1 short time after being fully charged, this means that the battery is
nearing the end of its life cycle. Contact service center for support.

HOW TO USE

1. To mount the brush head on the toothbrush. (Fig.2)
2. Put toothpaste on the brush head.
3. Place the brush head in your mouth.
4. Lightly press the "ON/OFF/Mode" button to switch on the toothbrush
and start to brush your teeth and the clean mode indicator will light up.
(Fig.3)
• Brush evenly throughout the mouth in four sections. (Fig.4)
1) Outside upper; 2) Outside lower;
3) Inside upper; 4) Inside lower;
5. Guide the brush head slowly from tooth to tooth.
• Hold the brush head in place for a few seconds before moving on to
the next tooth.
• Brush the gums as well as the teeth, first the outsides, then the
insides, finally the chewing surfaces.
• Do not press too hard or scrub, simply let the brush do all the work.
6. Press"ON/OFF button" to turn on the brush, then press the "Mode
button" to select the preferred mode from "Clean, Polish,Gum care",the
mode indicator will light up. first use or sensitive gums, suggest you
select "Gum care" mode.
11
EN EN
7. At each mode brushing, it's 30 seconds intervals and 2 minutes
auto-off.
8. After brushing, press the "ON/OFF button" to terminate a brush.(Fig.3)
NOTE:
• A brushing time of 2 minutes is generally long enough to clean your
teeth properly. If you want you can brush longer than 2 minutes for an
even more thorough clean.
• When you first use your electric toothbrush you may experience slight
Fig.1
bleeding. This should stop after a few days when your gums get used
to the toothbrush. If the bleeding persists, Please consult your dentist.
• If you brush your teeth hard, the pressure sensor lamp will light up.
MAINTENANCE
1. Turn on the toothbrush and rinse the drive shaft under the tap to
remove toothpaste residues. (Fig.6)
2. Turn off the toothbrush, detach the brush head and rinse the inside
of the brush head (max. 60ºC). (Fig.7)
3. Turn on the toothbrush and rinse the brush head under a tap. (Fig.8)
4. Toothbrush head put back on the handle. (Fig.2)
5. Clean the toothbrush and charger with a soft moist cloth or paper
towel. (Fig.9)
6. When toothbrush is not in use for an extended period, unplug the
Fig.2
power cord and place the product into its box. Do not wrap the power
cord around the appliance.
NOTE:
• Replace the brush head every 3 months for the best brushing effect.
• Also replace the brush head when the bristles start to bend outwards.
• Any other servicing should be performed by an authorized service
representative or that the product has no user serviceable parts.
Fig.3
1
3
4
2
12
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9