Suntherm ALT LED 200 Bedienungsanleitung Seite 9

MOUNTING
1. Make a hole in the plasterboard of a size adequate to
the heating panel type (see page 7).
3. Press the springs on the opposite side of the panel into vertical
position and tuck their ends above the plasterboard edge
DISMOUNTING
1. Turn off the power. Pull down the edge with springs.
Press the springs into vertical position and pull out of
the hole.
2. Make sure the electrical power is turned off and connect both heater
and light into the separated electrical mains using terminal blocks. Then
slide the panel from the spring-edge side onto the plasterboard edge.
4. Insert the panel carefully into the hole.
2. Disconnect the panel from power and take it out
from the hole.
9