Herunterladen Inhalt Inhalt Diese Seite drucken

Further Safety Instructions; Noise And Vibration - TECMIX TMX PO 1200 Originalbetriebsanleitung

Poliermaschine inkl. transportkoffer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not run the power tool while carrying it.
Your clothing can be caught by accidental contact with the spinning insert tool and the insert tool can drill into
your body.
Regularly clean the ventilation slots of your power tool.
The motor fan draws dust into the housing, and a heavy accumulation of metal dust can cause electrical
hazards.
Do not use the power tool near flammable materials.
Sparks can ignite these materials.
Do not use insert tools that require liquid coolants.
The use of water or other liquid coolants may result in electric shock.
Setback and corresponding safety instructions
Kickback is the sudden reaction resulting from a hooked or jammed rotating insert tool, such as grinding wheel,
grinding disc, wire brush, etc. Hooking or jamming results in an abrupt stop of the rotating insert tool. This causes
an uncontrolled power tool to accelerate against the direction of rotation of the insert tool at the jamming point.
For example, if a grinding wheel hooks or jams in the workpiece, the edge of the grinding wheel that plunges into
the workpiece may become caught, causing the grinding wheel to break free or kick back. The grinding wheel
then moves toward or away from the operator, depending on the direction of rotation of the wheel at the jamming
point. Grinding wheels can also break during this process. Kickback is the result of incorrect or faulty use of the
power tool. It can be prevented by taking suitable precautions as described below.
Hold the power tool firmly and place your body and arms in a position where you can absorb the recoil
forces. Always use the auxiliary handle, if available, to have the greatest possible control over recoil
forces or reaction moments during run-up.
The operator can control the recoil and reaction forces by taking appropriate precautions.
Never bring your hand close to rotating insert tools.
The insert tool can move over your hand during recoil.
Avoid the area with your body where the power tool will move in the event of a kickback.
The kickback drives the power tool in the direction opposite to the movement of the grinding wheel at the
blocking point.
Work particularly carefully in the area of corners, sharp edges, etc. Prevent insert tools from bouncing
off the workpiece and jamming.
The rotating insert tool tends to jam at corners, sharp edges or when it bounces. This causes a loss of control
or kickback.
Do not use a chain or serrated saw blade.
Such insert tools often cause kickback or loss of control of the power tool.
Special safety instructions for polishing:
Do not allow any loose parts of the polishing hood, especially fastening cords. Stow away or shorten
the fastening cords.
Loose, co-rotating fastening cords can catch your fingers or get caught in the workpiece.

Further safety instructions

• Mains voltage and voltage specification on the type plate must match.
• Only press the spindle lock when the tool is stationary.

Noise and vibration

Die Geräusch- und Schwingungswerte wurden entsprechend EN 60745 ermittelt. Der A-
bewertete Geräuschpegel des Gerätes beträgt typischerweise:
• Sound pressure level: 90dB(A);
• Sound power level: 101 dB(A);
• Uncertainty: K= 3 dB.
• Total vibration value (when polishing paint surfaces with a sponge):
• Emission value ah = 2.5 m/s2
• Uncertainty: K= 1.5 m/s2
5
14

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis