How To Use - Zelmer ZGS1700 Benutzerhandbuch

EN PL
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commercial or industrial use
under any circumstances. Any incorrect use or improper handling of the product shall render the warran-
ty null and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label. Do not use, connect or disconnect the device to the mains with your hands or feet wet. Do
not use any accessories other than those supplied.
The mains connection cable must not be tangled or wrapped around the product during use. Do not pull
on the connection cord in order to unplug it or use it as a handle
Do not direct steam at people and animals.
Do not place the appliance under the tap to fill the water tank, or immerse it in water or other liquids.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact
an official technical support service. In order to prevent any risk of danger, do not open the device. Only
qualified technical personnel from the brand´s official technical support service may carry out repairs or
procedures on the device. Only an official technical support service centre may carry out repairs on this
product.
B&B TRENDS, S.L. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.
Before the first use
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on
clothes and there may be traces of dirt on the steam head.
Filling with water
Remove the mains plug from the wall socket before filling (or emptying) the garment.
Steamer with water
Press the 2 buttons at the same time to remove the water tank and pull out the water tank.
Remove the water inlet stopper. Fill the water tank with a maximum of 220 ml of untreated tap water.
Your appliance was designed to operate using untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened
water, rain water, filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners
as these may damage the appliance. These types of water contain organic waste, mineral elements that
become concentrated when heated and cause spitting, brown staining, leaking or premature wear on
your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water.
Close the water inlet stopper.
Return the water tank to its place on the appliance then plug it in.

HOW TO USE

Before the using please check the fabric´s label for recommendations.
We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to
ensure these fabrics are not damaged by hot steam.
Use a clothes hanger to iron your clothes.
Plug-in the appliance, a blue light will twinkle on the base. Turn it on by pressing the on/off switch. A red
light will twinkle on the button and the blue light on the base will change to bright. Wait until the light stop
twinkling and change to bright, meaning you can use the high power steam (approximately 20 seconds).
Press again and the light will change to blue, for smaller power steam. If pressed again the product will
stop operating and the blue light will twinkle on the base. Once selected the higher or lower power steam
you can use the product by pressing the steam button.
Press the steam button with the steam brush facing away from you holding it in a vertical position. For
7