Contact Information - Zelmer ZFH1900 Benutzerhandbuch

PL EN
B&B TRENDS SL accepts no liability for any damage that may be caused to people, animals or objects owing to
failure to observe this warning correctly.
INSTALATION (Fig. 3)
Install in accordance with applicable national safety standards.
1 Place the unit on a hard, rigid, flat, stable, horizontal surface free from vibration.
2 Keep all flammable materials away from the product, such as furniture, clothing, paper, curtains, etc.
Keep them at least 50 cm away from the unit. It is recommended to keep the air inlet and air outlet of the unit free
of objects: at least 1 meter from the air outlet and 50 cm from the air inlet behind the unit.
(3) Never place over the bathtub if the unit is located in the bathroom. Maintain at least a distance of more than 60
cm to prevent splashing, as shown in the figure.
INSTRUCTIONS FOR USE
The safety instructions marked at the beginning of this manual must be followed at all times when using this
product.
Follow the instructions below in order to switch on the appliance:
1. Remove the product from its original packaging taking special care not to damage any of its parts. Do not use
excessive force to remove the product from the box.
2. Switch on the appliance by selecting from the three speed settings (C).
3. Adjust the temperature using the thermostat control (D). The unit will be turned off automatically once it has
reached the selected temperature. lf the temperature of the room drops the product will turn back on, thus
keeping the temperature selected by the thermostat.
Repair:
Only specialized personnel should perform repairs to this electrical appliance. Any incorrect ly performed repair
can lead to considerable hazards for the user. In the event of repair, please always contact our aftersales service.
Failure to observe these instructions will lead to the total loss of the product warranty.
TROUBLESHOOTING
Possible operating anomalies.
INCIDENT CAUSE
The device does not work Appliance not switched on.
The unit is on but the selec-
ted temperature level in the
thermostat is lower than the
temperature of the room.
10
SOLUTION
Switch on the appliance using
the speed button.
lncrease the temperature level
ofthe thermostat (D)
lnformation requirements for electric local space heaters
ITEM SYMBOL VALUE UNIT
Heat output
Nominal heat P nom 1,8-2,0 KW
output
Mínimum heat P min 0,9 KW
output (indica-
tive)
Maximum P max,c 2,0 KW
continuous heat
output
Auxiliary electri-
city consump-
tion
At nominal heat el max 0,000 KW
output
At mínimum el min 0,000 KW
heat output
In standby mode el SB 0,000 KW

CONTACT INFORMATION

EN
PL
PARAMETER UNIT
Type of heat input, far electric storage local space heaters
only
Manual heat charge control, with integrated No
thermostat
Manual heat charge control with room and/or No
outdoor temperature feedback
Electronic heat charge control with room and/ No
or outdoor temperature feedback
Fan assisted heat output No
Type of heat output/room temperature control
(select one)
Single stage heat output and no room tempe- No
rature control
Two or more manual stages, no room tempera- No
ture control
With mechanic thermostat room temperature Yes
control
With electronic room tempera ture control No
Electronic room temperature control plus day No
timer
Electronic room temperature control plus week No
timer
Other control options (multiple selections
possible)
Room temperature control, with presence No
detection
Room temperature control, with open window No
detection
With distance control option No
With adaptive start control No
With working time limitation No
With black bulb sensor No
B&B TRENDS, S.L. - C. Cataluna, 24
P.I. Ca N'Oller 08130
Santa Perpetua de Mogoda (Barcelona) - Espana
C.I.F. B-86880473
11