Cleaning And Maintenance - N'oveen PTC09 Benutzerhandbuch

PRODUCT DESCRIPTION PTC09
A: Air outlet
B: Thermostat knob
C: Oscillation switch
D: Handle
E: Switch / selection of heating power
OPERATION
- Cold air (only ventilation): turn the knob on
- Heating at a lower power: turn the knob clockwise on setting: I
- Heating at maximum power: turn the knob clockwise on setting: II
AUTO SATETY SHUT OFF
The heater has a built-in safety device,which will switch the heater OFF in case of
accidental overheateing.To reset the heater,follow the next steps:
·Turn the control setting to the 'O' position.
·Unplug the heater and wait 5-10 minutes for the unit to cool down.
·After the unit has cooled, plug it in and operate normally.
·Turn salector switch into desired position(Fan,Low or High).
·Turn the thermostat switch to the desired temperature positon.
·When you feel the room temperature comfortable, turn the thermostat switch
anti-clockwise slowly to the minimal direction until the appliance switches off.
·The thermostat switch will keep the room temperature at the desired temperaturea
utomatically.
·You can also turn the thermostat switch anti-clockwise to the minimum position or
turn the thermostat switch clockwise to the maximum position to make the
temperature lower or higher.

CLEANING AND MAINTENANCE

·Be sure to switch off power supply and pull out the plug before cleaning.
·Wait for the heater to cool down sufficiently.
·Clean the body of the heater with a damp cloth. DO NOT ALLOW water into the
appliance.
·DO NOT use soap or chemicals which may damage the housing of the heater.
·Allow sufficient drying time before operating again.
·Clean the air inlets and outlets regularly with a vacuum cleaner(with a regular use, at
18