Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation location
When choosing the installation location, make sure that you can hear the alarm
from all sleeping areas. If you are installing only one CO alarm in your home,
install the alarm near the bedrooms, not in the basement or boiler room. The
recommended location for the unit should be at least 1.8 metres above the floor.
The unit is also suitable for placing on a table.
!
ATTENTION
Installation only by competent persons!
Assembly steps
• Drill two holes with Ø 5.0 mm into the wall. The distance between the two
holes must be 52 mm. Then insert the dowels supplied into the holes.
• Using a screwdriver, screw in the two screws supplied until the screw
heads still protrude about 5 mm from the wall.
• Test the unit by pressing the TEST/SILENCE button (2). Make sure that
the alarm sounds.
•
Place the unit on the screws with the suspension eyes on the back and
hang it.
Seite 35 von 46
Werbung
