Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quicklinks
Carrera D132 in-car chip SP43 installation
The latest Slot.it cars come equipped with special connectors to facilitate the installation of the Carrera D132
UK
conversion kit. Follow these steps:
1. Loosen chassis screws, take off chassis.
2. Connect end A to the front brushes quick-connector.
3. Connect end B to the motor quick-connector.
4. Place the model on the track and power it up through the D132 power base: the red LED must flash.
5. If the LED doesn't flash, turn the car 180° and power it up again: if the led flashes, and the direction is wrong, the
pickup wires must be inverted, or the inverting cable SP46 must be used between the pickup and the SP43 IC.
6. Proceed to programming according to normal Carrera guidelines.
7. If the LED remains OFF, or fixed ON, and you are sure that the D132 power base is OK, check all the wires and
contacts. If all seems OK contact us.
In case the chip is mounted on a Scalextric car equipped with Scalextric 4-PIN connector:
1. Loosen chassis screws, take off chassis.
2. Loosen bottom hatch screw, disconnect 4-PIN connector.
3. If Slot.it replacement hatch is used, securely fix the chip to it with the 2 clamps. Make sure the infrared LED is
visible from the bottom hole.
4. Connect the chip with the 4-PIN connector through the dedicated port.
5. Proceed to programming according to normal Carrera guidelines.
Note: If car has inverted polarity (car runs the wrong way), use inverter cable (CODE:
Slot.it FAQ #32 – Carrera D132 in-car chip installation
SP46), inserted between chip and
motor. An extra LED may be added
according to the instructions below
Compatible with SP32:
short (-) pin to 'K' square pad
long (+) pin to 'A' round pad
Full manual - voll Handbuch
2.00 en 1.00 21/04/2022
Werbung
Verwandte Anleitungen für Slot.it SP43
Inhaltszusammenfassung für Slot.it SP43
- Seite 1 1. Loosen chassis screws, take off chassis. 2. Loosen bottom hatch screw, disconnect 4-PIN connector. 3. If Slot.it replacement hatch is used, securely fix the chip to it with the 2 clamps. Make sure the infrared LED is visible from the bottom hole.
- Seite 2 Lockern Sie die Chassis’ Schraube und entfernen Sie das Chassis. Lockern Sie die Deckels Schraube und lösen Sie den 4-PIN Verbinder. Wenn Sie eine Slot.it Deckel benutzen, Fixieren Sie den Decoder mit den 2 Klammern. Die infrarot LED muss vom unterem Loch sichtbar aus sein.
- Seite 3 The 'Monoposto' model comes with two chassis, one of which is designed for either the oXigen type C or Scalextric SSD SP15c, or Carrera-compatible SP43 in-car ICs. The following instructions apply to SP43. Keep in mind that there is not much space in this tiny car, therefore installation requires patience and some skills, including soldering.
- Seite 4 Slot.it FAQ #32 – Carrera D132 in-car chip installation 2.00 en 1.00 21/04/2022...