Echogear EGLT2 Bedienungsanleitung Seite 9

STEP 2 I nstall the Wall Plate
For
WOOD STUD
INSTALLATIONS,
follow STEP 2A on PAGE 10
Min. Wood Stud Depth:
nominal 102 mm (4 in.)
½
actual 89 mm (3 in.)
Min. Wood Stud Width:
nominal 51 mm (2 in.)
½
actual 38 mm (1 in.)
Min. Wood Stud Spacing:
406 mm (16 in. )
Max. 16 mm (5/8 in.)
CAUTION:
Avoid potential
personal injuries and property damage!
Drywall covering the wall must not
exceed 16 mm (5/8 in.). Minimum
wood stud size: nominal 51 x 102 mm
(2 x 4 in. ) actual 38 x 89 mm
(1 ½ x 3 ½ in.).
For
CONCRETE
INSTALLATIONS,
follow STEP 2B on PAGE 12
Min.
203 mm
(8 in.)
Min.
406 mm
(16 in.)
CAUTION:
Avoid potential
personal injuries and property damage!
Mount wall plate 07 directly onto the
concrete surface (no surface covering).
follow STEP 2C on PAGE 14
CAUTION:
injuries and property damage!
Min.
●
Studs must be at least 2x4 in. / 25 ga.
203 mm
(8 in.)
●
If back side of wall is unfinished, drywall
must be installed to a minimum of one
stud left and right of the stud(s) being
Min.
used to install the mount
203 mm
(8 in.)
●
Drywall must be a minimum of 1/2 in. (13
mm) thick on each side of the studs, and
a minimum clearance of 1 ⅞ in. (48 mm)
behind the wall is required
●
Pilot holes MUST be drilled to a depth
of 1 in. (26 mm), using a 1/2 in. (13 mm.)
diameter drill bit
●
This product must be centered on the studs
●
Stud type and structural strength
must conform to the North American
Specification for the Design of Cold-
Formed Steel Structural Members
[362 S 125 18, C-Shape, S - Stud Section]
●
Drywall must be secured to studs with
screws 12 in. (304.8 mm) on center
For
STEEL STUD
INSTALLATIONS,
Avoid potential personal
9