Main Parts; Product Assembly - MoMi IRIS Handbuch

areas, playgrounds, school playgrounds, recreational areas.
• This product is intended for a single user with a maximum weight of 25 kg.
• Retain packaging or dispose of according to local regulations.
For the safety of children, do not leave freely accessible parts of the packaging (plastic bags, cartons,
etc.). Danger of suffocation!
• Check and maintain the bicycle regularly. Before each use of the bicycle, make sure that it is not
damaged and that no parts are missing or loose.
• Do not use the bike near bodies of water or other obstacles.
• Do not use the vehicle in the dark or in bad weather.
• It is forbidden to pull the bicycle behind a car or other vehicle.

MAIN PARTS:

1. Canopy
2. Pushbar
3. Handlebar grip
4. Handrail
5. Handlebar
6. Seat
7. Frame
PARTS TO ASSEMBLING:
1. Seat
2. Frame
3. Front wheel
4. Rear basket
5. Canopy
6. Backrest
7. Upper push bar
8. Plastic of steering

PRODUCT ASSEMBLY:

1. Grasp the frame of the bike and the rear wheel, then point the needle into the appropriate hole in
the frame until you hear a click. Pull the wheel towards you while holding the frame to make sure the
wheel is properly installed and does not fall off the frame. Repeat the same operation for the other
rear wheel (fig. 1).
2. Put the fender on the tube of the front wheel as shown in fig. 2. Make sure that the hole on the
fender is on the left side.
3. Insert the front wheel tube into the hole on the front of the bicycle frame. Make sure the wheel is
properly seated and there is no play. (fig no 3)
4. Insert the handlebar into the hole on the top of the bike frame, then tighten it with the screw and
make sure it is securely fastened (fig. 4 and 5).
EN
8. Rear basket
9. Fender
10. Rear wheel
11. Front wheel
12. Pedal
13. Footrest
9. Fender
10. Lower push bar
11. Steering rod
12. Pedestal
13. Rear whhel
14. Handrail
15. Handlebar
9