Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance And Cleaning - MoMi IRIS Handbuch

Dreirad
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5. On the frame of the bicycle, put the saddle pad with the convex side down so that it adheres well to
the frame (fig. 6).
6. Put a textile material on the seat, stretching it over the edges. Grasp the seat and unscrew the plastic
knob on the bolt protruding from the seat. Put the seat on the washer so that the screw goes through
the washer and the frame and its end protrudes from the bottom of the frame (fig. 7).
7. Tighten the screw with the plastic knob until you feel resistance and the seat is stationary (fig. 8).
8. In the appropriate holes on the outside on the back of the seat, insert one part of the securing rim
until you hear a click, pay attention to the direction of the rim. Repeat the same operation with the
other part of the securing ring. Pass one of the parts of the securing ring through the hole in the fabric.
Put the two parts together until you hear a click (fig. 9 and 10).
9. Insert the backrest into the remaining holes at the back of the seat, make sure that it is properly
attached and does not slide out (fig. 11).
10. Slide the hood over the tabs on the sides of the backrest (fig. 12).
11. Connect the two parts of the parent steering wheel. Insert it into the appropriate hole behind the
seat until you hear a click. From the bottom of the bicycle frame, put the plastic cover on the lower part
of the parental handlebar and tighten with the screw. Position the pad along the wheels (fig. 13 and 14).
12. Pass the steering rod through the hole in the front fender and the other end through the hole in the
plastic cap with pt. 10., tighten with the screw (fig. 15 and 16).
13. Slide the rear basket onto the rear wheel frame (fig 17)

MAINTENANCE AND CLEANING

Visor: Do not wash. Do not bleach. Do not tumble dry. Do not iron. Do not dry clean. Clean with a clean,
damp cloth and a mild soap. Allow to air dry. Do not submerge in water.
Seat cover, safety belts: Hand wash at max. 40 degrees C, do not bleach, tumble dry, do not iron, do
not dry clean.
Frame: Clean the frame with a soft, clean, damp cloth and a mild soap.
STORAGE: Keep out of the reach of children
10
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis