EVGA CLCx-Serie Installationsanleitung Seite 7

Fans and Radiator Installation
Install fans and radiator according to your system setup and airflow design. Use screws
to the radiator, use screws to attach the radiator to the case, and hex key
K
EVGA recommends that the pump should always be below the highest point of the radiator.
*Install to the top of the case
*Warning – The CLCx Cooler is not a passive cooler. Fans must be installed to the radiator for proper
operation of the CLCx Cooler, and failure to do so may cause irreparable damage to the pump and other
connected hardware.
J to attach the fan
to fasten the screws.
P
20mm UNC 6-32
Fan Screw
Install fans and radiator according to your system setup and airflow design. Use screws
to attach the fan to the radiator, use screws
L
fasten the screws.
EVGA recommends that the pump should always be below the highest point of the radiator.
*Install to the front of the case
*Warning – The CLCx Cooler is not a passive cooler. Fans must be installed to the radiator for proper
operation of the CLCx Cooler, and failure to do so may cause irreparable damage to the pump and other
connected hardware.
J and fan washers
to attach the radiator to the case, and hex key
K
30mm UNC 6-32
Fan Screw
Sleeve
to
P