First Operation - Forch VITON Bedienungsanleitung

Plastic Hand Pump VITON
ENG
1. Assembling of the telescopic suction tube
Screw the telescopic suction tube into the opening provided at the bottom
end of the pump body.
Turn the pump tube into one direction to make sure that it is tight-fit and sealed.

2. First operation

Pull the telescopic suction tube out according to the height of the container.
Tighten the nut on the telescopic suction tube to avoid the pump to draw air
when the liquid level is below the coupling nut. Then fix the hand pump onto
the barrel with the appropriate 2"-barrel thread, which is located at the bottom
end of the pump body. Now the hand pump is ready for operation.
Actuate the lever severeal times very strongly and quickly to allow the water
column to build up first.
A minimum filling level of 12-15 cm inside the container is required for the first
suction operation. Power: appox. 0,3 l/stroke, weight: approx. 1,1 kg.
Please be careful when pumping acids and alkalis.
This hand pump is not suitable for solvent and media of danger rating
A I and A II.
Please observe the relevant safety regulations and wear the necessary
protective clothing (gloves, protective goggles, etc.).
In case of doubts whether the hand pump is suitable for a particular liquid
with regard to material resistance (polypropylene, viton) please contact
Theo FÖRCH GmbH & Co. KG directly.