Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• The product contains a rechargeable battery.
• Fully charge the product once before using it for the first time.
• Connect the supplied USB charging cable to the USB connection
(2) on the product.
• Connect the free plug on the USB charging cable to a suitable
USB charger.
• To do this, consult the operating instructions for the USB charger
you are using.
• The status LED (3) lights up solid red during the charging
process. Once the battery is fully charged, the status LED (3)
lights up green.
Note – charging process / battery capacity
• A complete charging cycle takes about 90 minutes.
• The input stylus's rechargeable battery can be charged both
when it is switched on and off.
• If the battery capacity is less than 10%, the status LED (3)
flashes slowly blue and after around 10 seconds switches
itself off automatically.
• The actual battery life will vary depending on how you use the
device, the settings and the environmental conditions (batteries
have a limited life).
Note - Automatic switch-off
• Please note that the input stylus will switch itself off after 5
minutes of inactivity.
Note
To avoid damage to the display, please note the following points:
• Avoid exerting excessive pressure on the display with the
input stylus.
• Ensure that the display and input stylus are clean before
use. Small pieces of dirt such as grains of sand can cause
scratches when the input stylus is being used.
• Press the On/Off switch (3) to switch the input stylus on. The
status LED (3) lights up solid blue.
• Press the On/Off switch (3) to switch the input stylus off. The
status LED (3) goes out.
5. Care and maintenance
Only clean this product using a lint-free, slightly damp cloth and do
not use any harsh cleaners.
6. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
7. Technical data
Power supply
Current consumption
Battery type
Min. capacity
Typ. capacity
Weight
Dimensions L x Ø
System requirement -
Scribble function
Active "Pro" input stylus
5V / 1A
5 V
120 mA
Li-Po
130 mAh / 0.48 Wh
140 mAh / 0.52 Wh
14g
165 x 9 mm
- iPad OS14 or later
- Language support
3
Werbung
Inhaltsverzeichnis
