Assembling; Operation; Installation Scheme - profi-pumpe BRUNNEN-STAR 1500-4 Bedienungsanleitung

The pumps are designed for pumping clean water and chemically non-aggressive liquids. Any
guarantee is void in case of improper use. They are not suitable for pumping flammable liquids
or for use in places where there is a risk of explosion. The pumps are designed for home use in
the house and garden.
These pumps are designed for continuous use provided (max. 20 interruptions per hour). Never
run more than 2-3 minutes against a closed valve pump. (Install dry running protection) pump ade-
quately secured against dry running.
The pump must not be used in swimming pools.
Not suitable for use with solar photovoltaic panels.

4. ASSEMBLING

Due to their size, pump and motor modules
are delivered partly separately. The assembly
is carried out as shown in Figure.
Slide the motor shaft into the housing of the
pump shaft. Screw the two modules together.
Please make sure that the screws are tightened
crosswise and evenly.
Then mount the filter strainer as shown.
The filter strainer of the 6-inch pump is alrea-
dy installed in the pump component (visible
around the pump shaft).

5. OPERATION

5.1 Installation scheme

The installation must be performed
by a qualified professional.
Please, check each time before using, the
electrical connections and the cables are not
damaged. Check before the installation whether
the electrical connections are earthed according
to the statutory regulations and are installed.
The pump is to be secured through a RCD cir-
cuit breaker with release current of 30 mA.
Also, it is NOT recommended to perform, for
example, a cable extension. It is not certain
whether this modification is technically correct,
so this warranty is void. It must be ensured that
the pump is sufficiently cooled during prolonged
operation.
IMPORTANT!
5"
Flexible hose
Panzerschlauch
Towing rope
Zugseil
English 3
Pump
6"
Filter strainer
Motor
380-400V
Switch box
Schalter-Box