Hamron 009024 Bedienungsanleitung Seite 11

INSTALLATION
BEFORE INSTALLATION
WARNING!
Using defective accessories can lead to a risk
of personal injury and/or material damage.
• Read the safety instructions
• Check that the product has not sustained
any damage during transport or storage.
• Check that the inlet and outlet openings
are free from any packaging remnants
and contaminants.
INSTALLATION
1. Release the battery holder (1) by turning it
anti-clockwise.
2. Insert 2 LR20 batteries with the correct
polarity as shown by the markings in the
battery holder (1).
3. Screw the battery holder (1) back onto the
pump housing (2).
FIG. 2
1. Battery
FIG. 3
IMPORTANT:
• Insert the batteries with the correct
polarity. Do not mix different types of
batteries, or batteries with different
capacities or charging levels.
• Do not allow the product to run dry.
• Do not use the product for thinner or
solvents.
• Do not run the product upside-down
after use.
HOW TO USE
NOTE:
• Read all the safety instructions prior to
use.
• Do not use the pump for acids, acetone,
benzene or solvents.
• Never pump unfiltered liquids.
• Keep the hose away from heat, oil and
sharp edges.
• Check the hose for wear and damage,
and check that all connections are
correctly installed and tightened.
1. Immerse the suction tube's (2) inlet below
the surface of the liquid in the tank from
which pumping is to take place.
2. Insert the spout (5) into the filler opening
of the tank that is to be filled.
3. Turn the switch (1) to ON to start the
motor (3).
4. Press the gun nozzle's trigger (4) to start
filling. Release the trigger (5) before the
tank is full and then turn the switch (1)
to OFF.
FIG. 4
LOW LIQUID FLOW
A low liquid flow may be due to the batteries
being discharged, in which case you should
change the batteries, or to the liquid level
in the storage tank being too low. Top up if
necessary.
MAINTENANCE
• Remove the batteries when the product is
not in use.
• Wipe the spout clean of contaminants
and debris every week.
EN
11