Making Ice; Cleaning, Care & Maintenance - Polar T316 Bedienungsanleitung

EN
For Cleaning and maintenance
(GL192 only): you can remove
the cap on the sump drain to
drain all of the water from the
machine when the power is off.
Operation

Making Ice

Note: Before using for the first time (or
after a period of inactivity), clean the water
tank, ice basket and ice basket shelf. Use
the first ice making cycle to flush out the
system. Discard the water and ice created
from the first cycle.
1. Ensure the door is closed fully before use.
2. Press the Power switch to the On position [I].
The RUN light illuminates and the appliance
begins the ice making process. Each ice making
cycle takes approximately 25 minutes.
3. When the cubes reach the ice sensor ice
production stops. Production resumes once ice
has been removed from the bin.
6
T316_GL192_ML_A5_10_20221017.indb 6 T316_GL192_ML_A5_10_20221017.indb 6
4. Press the Power switch to the Off position [O]
Water inlet
at any time to halt the ice making process.
Drainage valve
cap
Water outlet
Model: T316 To avoid contamination of ice, please respect
the following instructions:
• Opening the door for long periods can cause a
significant increase of the temperature in the
Drainage valve
compartments of the appliance.
cap
• Clean regularly surfaces that can come in
contact with ice and accessible drainage
Water inlet
systems.
Water outlet
• Clean water tanks if they have not been used
(attach the drain
for 48h; flush the water system connected to a
hose here)
water supply if water has not been drawn for 5
days.
Sump drain
• If the refrigerating appliance is left empty for
long periods, switch off, defrost, clean, dry,
and leave the door open to prevent mould
Model: GL192
developing within the appliance.
Cleaning, Care &
Maintenance
• Always switch off and disconnect the power
supply before cleaning.
• Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
• Clean the water filter regularly with a small
brush, particularly in hard water areas. The
water filter is located just inside the water inlet
at the back of the appliance.
• If the Ice Maker is to be left unused for longer
than 24 hours, loosen the drain valve cap and
drain the water from the tank.
• The inner removable parts and water tank
should be cleaned regularly.
Note: Ensure metal rack is
pushed as far forward as
possible against plastic ice
curtain to allow ice to fall.
Filter for the drain system (for
GL192 only): Check the filter
monthly and clean if required.
Ensure the filter is repositioned
correctly after cleaning.
2022/10/17 11:59 2022/10/17 11:59