Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLY
ATTENTION
×
Assembly must be carried out by an adult. Keep children away, the product contains
small parts that can cause suffocation, pay special attention to protective materials
and packing bags.
×
Make sure that the power switch is set to "OFF" before assembling the equipment.
−
Before first use, charge the battery for at least 10 hours.
INSTALL STEERING ROD AND FRONT AXLE
1.
Turn the body from the bottom upwards. There are 11 screws at the front axle mounting and
steering lever position. Remove them with a screwdriver. Insert the steering rod into the fixing
hole and lock the fixing part with 3 screws. Install the front axle assembly in the alignment, lock
it and secure it with 8 screws.
INSTALL SHOCK ABSORBERS
1.
Lift the rear drive motor assembly, locate the long bolt and remove it along with the four gaskets
and one nut pre-installed on it. The bolt passes through the gasket, damper, gasket, body,
gasket, damper, gasket, gasket, nut, and is tightened with the spanner.
11
*
42
Werbung
Inhaltsverzeichnis
