hkoenig KBP40 Bedienungsanleitung Seite 8

BEFORE FIRST USE
1. Unpack the appliance, then check and make sure that all the accessories including ice
basket and ice scoop etc. are complete. Please contact with the client service department if
some accessories are missed.
2. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45°during transportation or
use. Do not turn the ice maker upside down. Doing so could cause the compressor or
refrigerating system to operate incorrectly. Please allow time for the fluids in the compressor to
settle after the ice maker is moved or transported. Before using the ice maker for the first time,
please wait for 2 hours after the unit has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient ventilation, far
from heat sources such as ovens, heaters and corrosive gases. Leave an 8-inch (20cm)
clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to
fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5℃).
7. Clean the appliance by following the operation of "CLEANING AND MAINTENANCE"
before operate.
USING YOUR ICE MAKER
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the "
NOTE: Please make the ice maker be rested for 30 minutes before plug if it has been moved.
3. Open the top lid and remove the ice basket.
4. WARNING: Fill the water reservoir with potable water only.
NOTE: Do not fill above the MAX water level mark.
5. Alternatively, you can operate the Ice Maker under the condition that it is supplied with
water continuously by following the operation as below:
(1) Firstly prepare a 1/4 water tube (outer diameter:φ6.35mm) about 2m in length and then
insert its one end into the water inlet of Ice Maker.
(2) Check and make sure that the three-way ball valve equipped is compatible with the water
tube and water faucet in your home.
(3) After checking, connect the three-way ball valve with the tap water.
(4) Connect the other end of the 1/4 water tube with the 1/4 tube connector of the three-way
ball valve.
(5) Check and make sure all the connection of water tubes are tightly connected and then
open the three-way ball valve after confirmation.
6. Replace the ice basket and close the top lid.
7. Press " " key to select the ice size, " " means small ice while "
8. Press the "
9. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient
temperature and water temperature
10. The ice-making cycle starts with water being pumped into the ice tray situated below the
" key and the " "indicator lights solidly.
" indicator blinks.
" means large ice.