humanscale Nova Installationsanleitung Seite 17

FCC/CAN ICES Notice
Wireless Charging Desktop Base for Nova Series Model N
FCC ID: 2AMDTWCDB
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
To ensure compliance with FCC and ISED RF exposure requirements this device must be installed to provide a minimum
of 20cm between the device and people.
The FCC requires the user be cautioned that any changes or modifications made to this device that are expressly ap-
proved by Humanscale may void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC: 23760-WCDB
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:1.This device may
not cause interference. 2.This device must accept any interference, including interference that may cause undesired
operation of the device.
To ensure compliance with FCC and ISED RF exposure requirements this device must be installed to provide a minimum
of 20cm between the device and people.
Pour garantir la conformité aux exigences d'exposition RF de la FCC et d'ISED Canada, cet appareil doit être installé de
manière à laisser un minimum de 20 cm entre l'appareil et les personnes.
Cet appareil est conforme aux exigences des États-Unis en matière d'exposition aux ondes radioélectriques, de la FCC
et d'ISED Canada. Il est conçu et fabriqué pour ne pas dépasser les limites d'émission imposées pour une exposition
à l'énergie de radiofréquence (RF). Pour satisfaire aux exigences de conformité en matière d'exposition aux radiof-
réquences, les opérations portées sur le corps sont limitées aux pinces de ceinture, étuis ou accessoires similaires ne
comportant aucun composant métallique dans l'assemblage et doivent ménager une distance minimale de xx mm entre
l'appareil, son antenne, et le corps de l'utilisateur.
17