Mode Switching; Standby Mode - DeLUX M912DB Benutzerhandbuch

Instructions
Screen Display
The mouse is equipped with a screen which can display mode name, DPI gear and
battery capacity.

Mode Switching

The mouse can be used as wired, wireless using 2.4G or wireless using Bluetooth 5.0
(dual channel). Short press the mode button at the bottom to cyclically switch between
USB/2.4G/BT1/BT2 modes.
The wireless mode can be shown by the corresponding indicator (indicators will be all of
in the wired mode), and the screen displays the current mode name.
Charging
The mouse has 1000mAh lithium battery. The top indicator is always on with steady red
light when charging, and the screen will display the lightning icon and the battery
dynamic change icon. When fully charged, the top red light will be off, the lightning icon
will disappear, and the battery capacity will display 100%.
Stand-by Mode
The mouse enters stand-by mode when not used for some period of time. To wake up
the mouse, just move it slightly.
Coding
Short press and switch the mode of 2.4G or Bluetooth, then long press the mode button
for three seconds. The mode indicator flashes quickly to indicate that the code has
entered the pairing state, and the screen flashes to display the mode is unconnected.
Please insert the receiver into the port of your PC. (The receiver should be within 30 cm
of the mouse.) After the binding is successful, the screen will display the complete
information.
In Bluetooth mode, search for the mouse (DELUX) and connect to it. When pairing, the
screen will display "unconnected", and the screen will display "connected" upon
successful pairing.
4