REMEZair RMCH-403-01 Bedienungsanleitung Seite 9

ENG
DEVICE INCLUDED
Two ice boxes
Composite filter HEPA + carbon
User manual
Remote control
Aquafilter EcoGreen
Booklet
INSTALLATION AND USE OF THE DEVICE
• After removing the device from the package, place it on a flat, dry surface and connect to a
power source.
• After connecting to a power source, you will hear two beeps and the device will enter
standby mode.
• In standby mode, press the «On/Off»
turned on, the fan speed indicator lights up. All other functions are disabled.
When using the device during summer (>20°C) in the Humidification and Cooling mode,
natural air flow is required. It is recommended to install the device with the air intake
towards a window.
1. «Humidification and Cooling» mode
For the device to operate in this mode, it is necessary to pour clean water into the water
tank. When adding water to the tank, be careful - the water level should not exceed the
maximum level and should not be lower than the minimum. Press the «Cool»
to turn on/off the «Humidification and Cooling» mode. The corresponding indicator will
appear on the display.
When this mode is turned on, water from the reservoir is supplied to the EcoGreen
aquafilter, saturates it with moisture, and the process of natural humidification and cooling
begins. The effect of moisturizing and cooling is felt 5-10 minutes after turning on this
mode, since the aquafilter must be saturated with water.
Climate system RMCH-403 is not an air conditioner because it does not use a compressor
or refrigerant. It naturally cools the air, keeping it fresh, comfortable and chilled.
2. Fan speed
After turning on the device, press the «Speed»
following sequence:
Digital display: (1) → (2) → (3)
Speed levels: low → medium → high
3. Fan operation modes
After turning on the power, press the «Mode»
3 fan modes:
Night mode
Basic Mode
Breeze mode
During the operation of the modes, the corresponding indicator on the display lights up.
Basic mode
The fan operates at a fixed speed set by the user.
button to turn on the device. The first time it is
button,
button to switch the fan speeds in the
button,to switch the fan modes.