CAVOE IDEO Gebrauchsanweisung Seite 9

10. The warranty is valid within the European Union.
11. The consumer goods warranty does not exclude or suspend
the purchaser's rights stemming from goods non-compliance
with the agreement.
OPERATION MANUAL
UNFOLDING THE PRAM
To unfold the pram straighten up the upper part of the guide
(pic. 1). Next press the securing button and twist the folding
mechanism towards direction pointed with arrow (pic. 2)
and move vigorously forward and lift it. Finally lift pram's backrest
(pic. 3 , 4).
ATTACHING AND REMOVING WHEELS
To attach the front wheels, push their hubs into the mounts
on the ends of the front tubes (pic. 5). To remove the wheels press
the button on the back of the wheel mounts and slide the hubs
out (pic. 6).
To attach the rear wheels, push their hubs into the mounts on the
rear suspension. (pic. 7). To remove the wheels press the metal
button on the bottom of the wheel mounts and slide the hubs out
(pic. 8).
ATTENTION! Make sure the wheels are correctly attached prior
to use.
PARKING BRAKE
The pram is equipped with a rear parking brake. To engage the
brake, press its lever down (pic. 9). In order to disengage it, lift the
lever.
NOTE! Before starting to push the pram, make sure that the brake
has been disengaged.
NOTE! Always engage the safety brake, when you leave the pram
on an inclined surface.
NOTE! The brake is not designed for slowing down. It should
be engaged after the pram has been stopped completely.
NOTE! The pram is not designed for running.
ASSEMBLY AND REMOVING THE BAR
In order to assembly the bar, insert its hooks on the handles on the
seat side tubes (pic. 10). In order to remove it, push the buttons
located in the lower part of the handles and slide the clips out
(pic. 11). There is no need to remove the bar before folding the
stroller.
NOTE! Never move the stroller by holding the bar.
NOTE! Using the bar does not exempt from the obligation to use
the seat belts.
FOOTREST ADJUSTMENT
To unfold the footrest pull the leverage at the front (pic. 12). To lift
it just push it up (pic. 13).
CAUTION! The footrest is designed only to support child's legs.
If a child is in seating position, the footrest must be lowered.
BACKREST ADJUSTMENT
The stroller has 3-step adjustment of the backrest. In order
to lower the backrest, pull the lever on the rear of the backrest and
set the desired position (pic. 14). In order to raise the backrest, just
push it upward. It locks automatically in that position.
SAFETY HARNESS
The pram has a five point safety harness appropriate for children
from birth.
The shoulder straps should be adjusted to the child's age. There
are two pairs of slots in the backrest for the shoulder straps.
The lower slots should be used for children less than six months
old. The upper slots should be used for children more than six
months old.
To put the five point safety harness on, connect the shoulder straps
with the hip straps and then slot them into the central buckle
attached to the groin strap. Adjust all the straps and belts so that
they are snug with the child's body but at the same time are not
uncomfortable (pic. 15, 16). To open the harness press the button
on the central buckle and disconnect all straps (pic. 17).
ATTENTION! If the pram is used to carry a child less than 6 months
old, the backrest has to be in a "lying down" position.
SWIVEL SEAT INSTALLATION AND REMOVAL
To install the swivel seat, plug its pin into round holder on the pram
(pic. 18).
CAUTION! Make sure that the seating is properly installed before
use.
To remove the seat pull the plastic leverage under the seat (pic.19).
FUNCTION OF SWIVEL SEAT
There is a swivel seat function. To rotate it set the backrest
in seating position, lift the footrest to vertical position and pull
the footrest adjustment leverage (pic. 20). In this setting you can
rotate it (pic. 21A, 21B). The seat will lock automatically facing or
inversely the driving direction, and you shall hear characteristic
locking sound.
PRAM FOLDING
Set the seat inversely the driving direction. Tilt the backrest far
forward (pic. 22). Next press safety button and twist the folding
mechanism towards pointing arrow direction and push the guide
down and forward (pic. 23). Push the frame until it is locked. Once
again press the safety button and twist the folding mechanism to
entirely fold the guide (pic. 24, 25, 26).
You can also fold the pram with seat facing driving direction,
following the same steps, but it's size after folding will be much
bigger and irregular.
en
9