Led Indicator - FLYLINKTECH CF200 Bedienungsanleitung

In any of the following situations, the smart clamp turns on protection mode:

LED Indicator

The red and green lights flicker alternately
The green light is always on and the buzzer
sounds once
The red LED is always on and the buzzer
keeps beeping
The green light flashes slowly
The red LED light is always on
Security Indication
1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles,or it will cause serous damages to the unit.
4. Only jump start your car when 3 to 4 indicator lights are illuminated.
5. Do not connect two clamps together when the starter is powered on. And do not connect both cable clamps to the
same piece of metal.
6. If the engine does not start on the first try, disconnect it from the car battery and wait for at least 20 seconds before
reconnecting. Maximize three attempts in two minutes
Situations
ready to work
work status
1.Short circuit protection
2.Reverse protection
----Need to re-plug the clip to cancel the alarm status
Low voltage protection
----Need to re-plug the clip to cancel the alarm status
1.High temperature protection
2.Anti-charge protection
----Need to re-plug the clip to cancel the alarm status
05
English