Fault Clearance And Maintenance; Fault Clearance Checklist - Smeg SGR10S Betriebsanleitung

SGR10S

4 Fault clearance and maintenance

4.1

Fault clearance checklist

Malfunction
Device does not switch on
Device is not heating
No material transport
Non-symmetrical material
transport
Loud running noise
Sealing seam does not
hold up
Sealing seam distorted or
melted
Page GB 9
All manuals and user guides at all-guides.com
Fault clearance and maintenance
Possible cause
Network connection
Power cable not plugged in
Power cable defective
Mains fuse
Target temperature too low
Overtemperature cutout has
triggered
Temperature regulator
Heating element
Solid state relay
Target temperature not reached
Motor defective
Microswitch defective
Toothed damaged
Tooth belt not transporting
Motor defective
Sealing temperature too low
Clearance between sealing dies is
too large
Sealing temperature too high
9.696.035
ENGLISH
Chapter 4
Remedy
Check network connection; connect
another plug if necessary
Replace power cable
Replace mains fuse.
In the event of fuses blowing
repeatedly you must compulsorily
have the device checked!
Increase target temperature
Press in overtemperature cutout.
In the event of repeated triggering
you must compulsorily have the
device checked!
Replace temperature regulator
Check heating elements and replace
if necessary
Replace solid state relay
Replace motor
Replace microswitch
Replace toothed belt
Check toothed belt tension
Replace motor
Increase sealing temperature
Set the sealing die to 0.5mm
Reduce sealing temperature
Version 1.02