Witter BM37U Montageanleitung

Fitting
Instructions
MATERIALS
A 1 Main Crossbar
B 1 Z50 Flip up Electrical Plate Kit (Optional)
C 4 Existing M12 Nuts (M12 – 80Nm)
D 1 Flip Up Electrical kit (Z99)
E 1 Flip Up Profile Bracket (ZEQ7)
ZQ 1 Detachable Neck illustrated.
For use with 3007 series necks
FITTING
On underside of bumper remove 6 screws. Within wheel arch remove 1 plastic plug and 3 screws. Ease back trim.
1.
Exposing 1 tip screw remove.
Open boot and remove plastic trim on inside of lights. Remove 1 nut on each light, and unclip wiring loom. Pull lights
2.
rearward and store.
Carefully slide bumper rearwards prising bumper clips apart from plastic frame and disconnect reverse sensors.
3.
Remove & retain crash beam and 2 nuts either side. Note: Crash beam must be refitted over Main Crossbar.
4.
Keep gaskets in place and fit Main crossbar (A) to vehicle using existing crash beam mountings. Refit main crash
5.
beam over crossbar (A) using original nuts (liquid thread lock recommended). Tighten crash beam and main crossbar
to vehicle.
6. Re-attach bumper using original fixings and refit sensors. Note: Ensure bumper fits fully around the inner arch
plastic trim before tips are fitted otherwise this will prove to be difficult.
Attach preferred neck (see separate fitting instruction) and fit flip up electrical plate (Z50 or Z99).
7.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
For BMW 1 SERIES 5 DOOR HATCH
W0001BM37U-FIT$010811110000`Ä
W0001BM37U-FIT$010811110000
TOWBAR
BM37U
2011-