Profile PCL-506 STRATUS Bedienungsanleitung Seite 12

Stratus Air Purifier
PCL-506
We thank you for the purchase of this Profile product.
Note: It is important that you read this manual before
using the product. Then keep this manual in a safe place.
Technical information
 Power: AC 230V 50Hz
 Dimensions: 343 x 255 x 610 mm.
 Weight: 6850g.
 Power consumption: 80W
 Active oxygen output: < 0.05 ppm
 Air volume: Max. 0.3m³/Min.
 Cycle repeat: 1/2/8 hours.
 Functions fully electronically
 Functions based on the ionising principle
 ionisation output: > 2 x 10
 Suitable for spaces up to 170 m³.
 Standing model
 This model is fitted with a HEPA filter.
display:
receiver
remote control
Operation and installation
 This appliance is suitable for ventilating spaces up to
170m³.
 Place the appliance at least 30 cm from the wall.
 Keep the appliance away from children.
 Before starting to use the appliance allow fresh air into
the space through open windows. Insert the air purifier
plug in the plug socket and press the ON/OFF button.
The odour sensor will memorise the freshness of the
air then clean the air in the living room to the
measured level.
 Once started the odour sensor will flash while the fresh
air is measured. After approximately 2 minutes the
odour sensor will indicate that memorising has ended.
 NOTE: each time you pull the plug out of the plug
socket the memory will be deleted.
 When the ionizer is working a blue indicator will dim on
and off every 5 seconds.
 When the air purifier detects soiling such as smoke the
odour indicator lights up.
 The dust indicator will also light up when much dust is
detected in the air.
6
/cm³
odour sensor
 Finally, the appliance also has an air quality
indicator that indicates how much soiling there is in
the air.
 Press the ON/OFF button to switch the appliance
on. Press again to switch the appliance off again.
 This air purifier has 5 different ventilation levels to
clean the air.
 To automatically operate the air purifier press the
FAN button until the LED displays AUTO.
 When the appliance is set to AUTO it will itself
select the level (medium – low) depending on the
amount of soiling in the air. When the air has been
sufficiently cleaned the appliance will automatically
go into stand-by mode.
 Press the AUTOTIMER button to set the duration.
You can choose a cycle of 1/2 to 8 hours by
repeatedly pressing the button. When the air is
sufficiently clean the appliance switches to the
stand-by position. The cycle repeats according to
the set cycle time.
 You can switch the ionisation function on and off
with the ION-UV button.
 The air purifier also has a remote control.
EN - 1
No soiling detected.
A little soiling detected.
Serious soiling detected.