Air Filter - Zibro A 40 Gebrauchsanweisung

C. AIR FILTER
The A40 air purifier is equipped with a 4 layer filter package to clean the circulated room
air.
• HEPA (High Efficiency Particulate Airfilter) filter captures allergens like bacteria, dust
and pollen.
• Enzyme filter neutralizes airborne micro organisms.
• Active carbon filter removes unpleasant odours from the air.
• Screen filter captures large dust particles.
The HEPA/Enzyme filter and activate carbon filter continue to work for a long period of
time after opening. The frequency of use and operating conditions determine how often
the filters must be replaced. When the filter is new, the vertical filter lifetime bar lights up
green. Depending on the conditions, the lights will be de-activated stepwise. When the
filter is saturated, the 'Filter' light
following steps:
1 Switch the device off and remove the plug from the socket.
2 Unfasten the front panel
3 Remove the screen filter
and the activated carbon filter
4 Clean the screen filter
5 Install the new activ carbon filter, followed by the HEPA-/Enzyme-filter and finally the
screen filter (see section B).
6 Press the reset button
'Filter' light
displayed.
7 Dirty filters can be disposed of with household waste (not biologically degradable
waste) without any problem.
8 New filters are available at your dealer.
ATTENTION!
• Always replace dirty filters with new filters. Never re-use a dirty filter, even
• Depending on the circumstances it might be comfortable to replace the filters
4
46
with the push tabs
from the device and then remove the HEPA-/Enzyme-filter
with a vacuum cleaner.
after installing the screen filter
will remain on and the following filter replacement will not be
after it has been cleaned.
more frequent.
switches on (red). When this happens, take the
on both sides of the device.
.
. If you do not do this, the