JBM 60004 Bedienungsanleitung Seite 4

EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This LED working light has been designed to ensure a perfect
illumination of the working area and any other place. Its opera-
tion with the portable lithium battery makes it ideal to move it
freely all over the workplace, as well as in situations when there
is no access to the electrical power supply. Even so, if the bat-
tery runs out, it is possible to connect the power cable provided
into the slot at the rear side of the work light and plug it into the
230V power supply.
The LED light lens provides a light output which can be adjusted
to 1200 and 2400 lumens, and the work light head features a
360º adjustment angle to adapt the direction of the light bulb
as appropriate.
SAFETY INSTRUCTIONS
• Check for breakage of parts, damage to switches and any
other conditions that may affect its operation.
• Disconnect the battery from the tool and place the switch in
the locked or off position before making any adjustments,
changing accessories, or storing the tool.
• Keep the working area clean and well illuminated.
• Do not operate the tool in the presence of flammable li-
quids, gases, or dust.
• Keep children and non-authorized people away from the
tool while in use.
• Do not operate the tool if you get tired easily or under the
influence of drugs, alcohol or medication.
• Dress properly. Do not wear loose clothing or jewelry and
contain long hair.
• Remove adjusting keys or wrenches before turning the
tool on.
• Use safety equipment. Always wear safety glasses and
use a dust mask, non-skid safety shoes, safety helmet or
hearing protection when necessary.
• Do not use the tool if the switch does not longer work and
repair it immediately.
• Store the tool out of reach of the children while not in use.
• Do not expose the tool to rain or wet conditions.
• Do not modify or open the work light in any case, all elec-
tronic parts are fixed already.
• You must change a cracked glass before using the work
light again.
OPERATION
Adjusting the light direction
This led work light has an angle adjustment of 360º:
1. Loosen the side locking knob.
PARTS LIST
2. Turn and adjust the work light head to the desired position.
3. Retighten the knob.
Turning On/Off
This led work light has an On/Off switch that can also be used to
adjust the LED work light brightness:
1. Press once to turn the light on in its low mode (1200 lm)
2. Press twice to turn the light on in its high mode (2400 lm)
3. Press three times to flash.
4. Press four times to turn the light off.
NOTE! Do not stare directly at the light beam or point the beam
at any person.
NOTE! If the battery is out of power, you can connect the power
cord into the slot at the rear side of the work light and plug it into
the 230V power supply.
MAINTENANCE
• Always be sure that the tool is switched off and the battery
pack is removed from the tool before attempting to perform
inspection or maintenance.
• Do not use cleaning agents to clean the plastic parts of the
tool, a mild detergent on a damp cloth is recommended
instead.
TECHNICAL SPECIFICATIONS
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . DC-20V
Max output . . . . . . . . . . . . . . . . . 1200 lm (low mode)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . 1.35 kg
NUM.
1
2
3
4
5
6
· 4 ·
2400 lm (high mode)
DESCRIPTION
Work light head
LED's Lents
Side locking knob
On/Off switch
Battery release button
Battery
REF. 60004