RAYZ Rally Pro SP-01 Nutzerhandbuch Seite 32

CE DECLARATION OF CONFORMITY (EUROPEAN UNION)
Appcessori Corporation hereby declares that this device is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU, Directive 2014/35/EU, Directive 2009/125/EC, and Directive
2011/65/EU as amended by (EU) 2015/863. The Declaration of Conformity may
be obtained from:
Company: Appcessori Corporation
Address: 915 Broadway St Ste 258
Vancouver, WA 98660, USA
This device operates at 2402 MHz to 2480 MHz with an RF Output Power
(EIRP) of +4 dBm (2.5mW).
European Union — Disposal Information
The symbol to the right means that according to local laws and
regulations your product and/or its battery shall be disposed of
separately from household waste. When this product reaches its end
of life, take it to a collection point designated by local authorities.
The separate collection and recycling of your product and/or its
battery at the time of disposal will help conserve natural resources and ensure
that it is recycled in a manner that protects human health and the environment.
End-of-Life Battery Removal Instructions
These instructions are for qualified personnel only at a waste processing
facility. These instructions are not intended for end users.
1) Remove the soft rubber material on the back of the unit. Use a fingernail or
wooden prying tool on a corner and then slowly peel it off diagonally.
2) Remove the rigid plastic material on the back of the unit using a similar
process as above.
3) Unscrew the eight screws with a T8 screwdriver and gently lift up the rear
housing from the main housing.
4) Looking inside, on the bottom right of the circuit board there is a white
connector with red, yellow and black wires. Gently unplug that connector
5) Remove the battery which is located on the underside of a plastic plate
below the speaker driver.
6) Use a wooden or plastic tool to carefully pry the battery from the plastic
plate without deforming the battery.