Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
Measuring Principle
20
12
4
0
Sensor
housing
Sensor rod
Fig. 1
Measuring Principle of an eddy current long stroke dis-
placement sensor, alu tube is shown at the start of the measu-
ring range
5.
Electrical Connection
Connector 5-pins, CA02COM-E14S with bayonet connection
6.
Unpacking, Shipping
Do not take and hold the sensor
at the sensor rod.
Check for completeness and ship-
ping damage immediately after
unpacking.
induSENSOR, EDS, model F
1/2
1/1
Measuring range
Alu tube
7.
Installation and Assembly
7.1
Measuring Tube Guide and Fastening
Mount the measuring tube in the piston borehold.
The dimensions for the measuring tube, see
is moved in the measuring tube must not touch the sensor shaft.
Observe the measuring tube position at the zero point (= 4 mA out-
put), see
Fig.
2. A slightly eccentric mounting of the measuring tube
has no negative influence on the sensor signal.
Mount the measuring tube in the piston by means of pressing
or glueing.
Spot clamping is not permissable.
i
The specified technical data are valid only if the
measuring tube is used supplied by MICRO-EPSILON!
a
Fig. 2 Zero point of the measuring tube
Measuring
100
160
range
20
20
Dimension a
(0.79)
(0.79)
Fig.
4. When the piston
200
250
300
400
20
20
20
25
(0.79)
(0.79)
(0.79)
(0.98)
630
25
(0.98)
Page 9
Werbung
Inhaltsverzeichnis
