VONROC LB502DC Bersetzung Der Originalbetriebsanleitung Seite 9

• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. D)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (8) as shown in Fig. D.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(8) will lighten up and show the charger status.
The charger has 2 LED indicators (9) which indica-
te the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Assembling the tubes (Fig. B)
Always remove the battery before mounting
an accessory.
• Slide the upper tube (4) onto the motor housing
until it clicks into place.
• Slide the lower tube (5) onto the upper tube (4)
until it clicks into place.
WWW.VONROC.COM
4. OPERATION
Switching the machine on (Fig. A)
To switch on the leaf blower, press the On/Off
switch (1) to position 1 or 2. Position 1: Blowing
light materials. Position 2: Blowing heavy materials.
To switch off, push the On/Off switch 1 to the stop
in position "0".
Switching the machine off (Fig. A)
Move the On/Off switch (1) to the "0" Off position.
5. MAINTENANCE
Charger status
No power
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
Standby mode:
ventilation openings are free of dust and dirt. Re-
- No battery is
move very persistent dirt using a soft cloth moiste-
inserted or,
ned with soapsuds. Do not use any solvents such
- Battery inserted
as gasoline, alcohol, ammonia, etc. Chemicals such
but charging has
as these will damage the synthetic components.
fi nished
Battery charging in
ENVIRONMENT
progress
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
EN
9